The channel weave poles are designed to teach the dog to run straight down a channel created by the poles. When turned out, the poles create a channel about 15 inches wide. When turned in, the poles align on the center of the ground support. Each pole is counter balanced and designed to twist easily in and out for the channel width that you desire.

The base pipe and pole support are glued together as you see in this photo. This allows you to use as many poles for training as you wish. The start of the poles is marked with green tape and the end is marked with red tape.

The distance between poles is 20 inches when turned in to create the regulation weave poles.

This picture shows the post support. The PVC portion that fits into the base is slotted so that it can be turned easily.


The overall channel weave assembly is divided into 11 pieces. This allows you to train using any number of posts that you wish.


The picture below shows a setup for 6 channel weave poles.


The picture below shows a setup for all 12 weave poles.


This picture shows the channel weaves in the " closed " position. Note that all poles align along the center pipe when they are in the closed position.